OnePlus 10 Pro aluminum dummy leaked, tips quad rear camera setup

Hinting at the OnePlus 10 Pro design has leaked in aluminum dummy form. The company is said to have gone back to the drawing board and reworked the camera module. In these leaked renders, the OnePlus 10 Pro seems to have the camera module in the corner instead of the center as before. The aluminum dummy render of the OnePlus 10 Pro also suggests the volume and power button placement of the upcoming phone.

Tipster xleaks7 (David Kowalski) has partnered with Fathom Bracelets Groove Aluminum dummy of OnePlus 10 Pro. The dummy reveals that the rear camera module has four sensors located inside with the flash at the centre. The slightly curved edges are visible in the OnePlus 10 Pro. The bottom edge is seen to sport a SIM tray slot, a USB Type-C port, and a speaker grille.

The tipster claims that the OnePlus 10 Pro could have a silent mode switch and a power button on the right edge, while the left edge could house the volume buttons. Also, even though the aluminum dummy doesn’t reveal any hints, it is speculated that the OnePlus 10 Pro may feature a hole-punch display design with a cutout on the top left corner of the display.

This aluminum dummy of the OnePlus 10 Pro is largely in sync with the previous leaks as well. The smartphone could be launched in the first quarter of 2022 and could feature the Qualcomm Snapdragon 8 Gen 1 SoC. Further, the smartphone flaunts a 6.7-inch (1,440×3,216 pixels) LTPO Fluid 2 AMOLED display with 120Hz refresh rate and 526ppi pixel density.

The OnePlus 10 Pro leak also suggests that the smartphone could come with up to 12GB of RAM and 256GB of internal storage. On the battery front, the handset could house a 5,000mAh battery.

,

Leave a Reply

Your email address will not be published. Required fields are marked *